Lining Processing Specification:
PO Lined High Performance Pipe And Fittings By Hot Rotomolding
Nominal diameter: DN25~DN3500, 1”~138”
Temperature range: -15°C~90°C
Applicable medium: Temperature range of -15°C~90°C, and full vacuum condition is applicable for any corrosive medium pipeline.
Youfumi manufactures lined pipe and fittings by compression molding, isostatic molding, injection molding, transfer molding, hot rotomolding, ram/paste extrusion, 3D rotational molding etc. Characters as below:
●Working temperature is high at the range of -29°C-200°C; except the molten alkali metals, element fluorine and aromatic hydrocarbon,
lined products can be used in any chemical medium.
●Vacuum resistance. In the range of -29°C-150°C, it is applicable for vacuum condition. In chemical production, the vacuum condition occurs due to cooling, longitudinal emissions, or medium backflow.
●High-pressure resistance. Within temperature working condition, it can sustain the working pressure of 3.0MPa.
●Resistance to penetration. Adapt the high-quality PTFE, to make it of high density and enough thickness after advanced lining processing, make it excellent antiosmosis.
●PTFE advanced lining molding process achieved the status of syn chronous hot expansion or cold shrinkage for steel components and fluorine plastic.
●Youfumi adopts the standard size according to HG, GB, DIN, ANSI, and JIS etc., which improves interchangeability, to provide convenience for installation.
Specific Gravity: 2.14-2.19g/cm3 as per ASTM D 792 test standard.
Tensile Rate: 20.7Mpa minimum as per ASTM D 638 test standard.
Elongation Rate: 250% minimum as per ASTM D 638 test standard.
Manufacture Standard: ASTM D 4895. Operating in vacuum condition within 150°C.